After successfully creating your activity, you can configure your track. To do this, click on "Edit devices" under "Management".
In the section "Timing" you can now select your devices under "Add new station". You must have at least two stations to be able to perform a measurement. In this example, a split time has also been used.
Each of your devices has a serial number. With this and the displayed color you can see which device is where. You can also see the status of your device by the status circle. You can move or remove stations using the menu:
When you are satisfied with the setting press "save". Now the system is ready to perform measurements.
Note: If you do not see any results, make sure that you have set the devices to the "Timing" state. Also check the start date of your activity again. If your devices have not been turned on for a while, wait for a GPS fix.
By adding multiple devices, any number of split times can be used.
A reference time can help you ignore false starts. This is particularly useful if an athlete fails to complete the course successfully. If one or more split times are used, a reference time can be set for each leg.
In the dialog you can now set the expected time and the deviation. Below you will see the time span in which the times may lie otherwise other triggers will be ignored.
Example: A reference time of 45 seconds and a deviation of 10 seconds was set. The valid time interval is now between 35-55 seconds. If an athlete starts and after 10 seconds someone crosses the finish line, this trigger is ignored.
The results can also be displayed on scoreboards. For this you only have to add your scoreboard and select which information should be displayed:
Keywords:
